CONTROLS
- Siemens PLC S7-300
*Allen Bradley SLC 5/03 PLC, also available at minimum
upcharge
- 24V control system
- Current overload protection
- Autoheight sensing photoeye with on/off mode
- Power on/off lockable switch and indicator light
- Three emergency E-stop stations
- Siemens monochrome Touch Panel
- Separate up and down carriage speeds
- Separate top and bottom wrap selections (0-9)
- Film force to load control
- Visual film break alarm
- Manual clamp jog
- Reset function
- Manual function for table fwd/rev., carriage up/down
- All conveyor sections fwd/rev.
- 15 Intuitives alarms diagnostic.
- Positive turntable home position braking system
- Air pressure switch
- Double brush dust tight slip ring
- On screen wrapping performance analysis
- On screen maintenance program and instructions
FILM DELIVERY SYSTEM
- 20" NO-THREAD® Powered Pre-Stretch
Carriage
- 1/2 HP AC motor with variable frequency drive
- 50-300% prestretch ratio (preset to customer
spec, Std 200%)
- Electronic film tension control with analog
sensor
- Sensing device for film out/broken
- Lexan roller cover
- Film force release for easy pull at start and
end of cycle
FILM CARRIAGE DRIVE
- 3/4 HP AC motor with variable frequency drive
- Two #50 chain carriage lifts for safety
- Dual ½" CRS ways with UHMW-PE carriage
glides
FILM TAIL TREATMENT
- Automatic film clamping
- Pulsed controlled cutter
- Film alignment arm
- Brush-on film tail treatment, Heat Seal available
*
TURNTABLE DRIVE
- Max. 15 RPM variable speed
- 1-1/2 HP AC motor with variable frequency drive
- Heavy duty Ring Gear Bearing drive
- Automated Lube Station.
- Electronic soft start/stop
- Positive turntable alignment controlled by proximity
sensor
- Electric brake
TURNTABLE CONVEYOR
- 77" dia. 1/2" steel plate
- 2-1/2" dia. rollers on 3" centers
- 1/8" wall cold rolled electric welded steel
rollers
- All rollers driven (including all surround rollers)
- 52" BFR (between frame rails)
- 3/4 HP AC motor with variable frequency drive
- Electronic soft start/stop
- #40 chain drive with contour driven rollers
- Heavy duty cast iron flange mounted bearing
CONVEYOR
- 5' in / 5' out powered contoured conveyor
- Standard: Pass height 18", other pass heights
available *
- 1/8" wall cold rolled electric welded steel
rollers
- 2-1/2" dia. rollers on 3" centers
- 52" BFR (between frame rails)
- All rollers driven via #40 chain
- 3/4 HP AC motor with variable frequency
drive including fwd/rev manual jog
- Heavy duty structural steel design
- Heavy duty cast iron flange mounted bearings
- Up to 35 feet per minute, other speeds available
*
- Additional conveyors and other types available
upon request. *
STRUCTURE
- Formed steel tower consisting of 11 gauge front
section and 14 gauge back cabinet section with
lockable door
- Forklift Portable base design (from both ends)
- Heavy duty structural steel construction
- Lag bolt brackets to secure machine to the floor
TECHNICAL INFORMATION
- The machine is provided with a manual including
electro/mechanical
schematics and drawings
- Trouble shooting guide
- Installation instructions
WARRANTY
- All Wulftec-automatic machines come with a three
year warranty.
All 25" ring gear bearings are warranted
for ten years.
- All Wulftec prestretch compound rollers have
a lifetime warranty.
OPTIONAL *
|
